TIMS Information TIMS Logo

Passengers Vehicle classification starting with "NDC"

NDC 95

Details: passenger car "NDC 95 K" in AN "Mainland Division".
Owner:AN
Operator:C
Length Over Headstocks:25m
Tare Weight:58.2tonne
Current Gauge:Standard
Gauge Restrictions:S
Bogie Configuration:2X2
Original Cost:$100810
Diagram Book Page No.:NN 14B
Date Built:15.11.1952
Operating System:AN
Intended Use:PASSENGERS
Remarks:DINING CAR
BSG Code:PSID
Capacity of 48 dining
 
Return to Service Date:10.03.1992
Last Lift:30.08.1976
16.07.1981Alteration "INSTALLATION OF STAINLESS STEEL SHELVES IN COOL ROOM. DRAWING NUMBER ISSUED (DC)(NDC)OC-110,(DD)OC-112,(DE)OC-109,(DF)OC-101 (14s81)".
17.12.1986Alteration "APPLY CHECK LETTER TO CLASS & NUMBER OF APPROXIMATELY 443 LOCOMOTIVES, PASSENGER CARS AND RAIL CARS. CLASSIFY OVERLAND SLEEPING CARS. (RS4173)".
20.08.1987Alteration "MODIFY BUFFER BEAM ON CARBON AND STAINLESS STEEL PASSENGER CARS. (RS4215)".
26.08.1987Alteration "MODIFY AIR CONDITIONING INTAKE FILTERS AND FRAMES (PRIMARY AND SECONDARY) ON STAINLESS STEEL AND CARBON STEEL PASSENGER CARS. (RS4213)".
15.03.1988Alteration "MODIFY BUFFER BEAMS AND FIT ADDITIONAL SPRINGS TO EITHER SIDE OF THE COUPLER TO INCREASE THE DIAPHRAGM COMPRESSIVE FORCE ON ALL STAINLESS STEEL AND CARBON STEEL PASSENGER CARS. (RS4270)".
21.06.1990Alteration "FIT LONGER PIN IN PASSENGER CAR JUMPER CABLE PLUGS. ALL PASSENGER CARS. (RS4518)".
28.05.1991Alteration "REPLACE EXISTING EXHAUST CHOKES ON 132 NO. "GHAN" "TRANS-AUSTRALIAN" "OVERLAND", "SS" & "SSA" CARS TO IMPROVE TRAIN HANDLING. ALL STD CARS TO BE FITTED WITH EXHAUST CHOKES TO WH P/NO. 2483 & THE 3 NO. RELAY BRAKED CARS ARE TO BE FITTED WITH WH P/NO. C-12740 EXHAUST CHOKES . THIS MODIFICATION WILL INCREASE BRAKE CYLINDER EXHAUST TIMINGS FROM 6-9 SECS TO 26-28 SECS. (RS4603)".
03.03.1992Repair "TRAIN PIPE (END)".
10.03.1992Repair "TRAIN PIPE (END)".


Australian National - Traffic Information Management System (TIMS) - data dumped on 30th May 1997
This page was last updated on Thursday 27 Feb 2014 at 11:34pm - see the readme file for additional information.